Vacuum flushing equipment, similar to MityVac
- Vacuum flushing equipment, similar to MityVac
- Locate bleeder, it's always at the top of the caliper close to the brake hose
- Remove rubber cap from bleeder, this keeps debris out
- Connect air source to flushing equipment, you should feel vacuum pull at end of flushing hose
- Open bleeder
- Install vacuum hose from flushing equipment to bleeder
- Let it run for a minute or two then remove hose
- Wait till fluid runs out free of bubbles, then tighten bleeder screw and reinstall rubber cap
- Remember to keep fluid topped off during entire operation, then on to the next wheel
- More >







