Skip to main content
  1. Tech
  2. Gadgets & Tech
  3. Tech Gear

Instructions to Repair the Touch Screen of Your iPad

See also

The Apple iPad, iPad 2 and iPad 3 are extremely refined gadgets. You simply need to open them up and examine the smoothly planned tablet to perceive how the stunning cerebrum of the mechanism capacities. One must be exceptionally watchful, as tough as they feel it simply takes one merciless drop or sway and the touchscreen may break. What happens when this frightening moment occurs in real? Well you can either take your iPad to tablet repair specialists or you could have an endeavour for repairing it on your own.

Repairing the iPad yourself

The focus is on the iPad 2 as it is the trickiest, and when you can displace a touchscreen on the iPad 2, the others are a breeze. It is best to begin at the base right corner around the range of 5 cm in from the corner. The best device to utilize is a restricted paint scrapper or an even surgical tool (The surgical blade is more unsafe as it can effortlessly trim important wires and cables so it is advised to use the paint scrapper in the event that one is doing first time). You will likewise require a high temperature weapon or hairdryer to keep the screen warm whilst you evacuate it. This serves to dissolve the paste within. Be mindful so as not to overheat the screen as it can harm the LCD underneath.

Be watchful as the Wi-Fi link is stuck within the touchscreen about an inch to the right of the home bind. You have to gradually lift the touchscreen far from the packaging and disconnect the link from the touchscreen. Recall not harming the plastic bezel around the outside of the touchscreen. You can swap it; however in the event that you are cautious, you can effectively fit your opening device between the bezel and touchscreen.
Gradually move your opening apparatus around the iPad in a hostile to clockwise movement while warming. The following threat zone is the volume/on-off flex link in the upper right hand corner of the screen. Work quite gradually around this territory as to not harm this link; this is the link that most specialists still trying to figure out that how it breaks often. In the event that your iPad is the 3G model then you have to withdraw both the Bluetooth and 3g modules at the top either side of the Polaroid stuck within the touchscreen.

You should simply now slacken the bottom left corner and draw the touchscreen away as though you are opening a book. Do this quite gradually to draw the glue away. The touchscreen flex link is on the left close to the base, be mindful so as not to draw excessively hard on the link as regardless it needs to be detached from the fundamental board. You can now release each of the four screws around the LCD and at the end of the day lift the LCD out as though you are opening a book as the connector for the LCD is on the left. Separate the LCD utilizing the slim gold cut and hauls it out the board. You can now detach the touchscreen and uproot.

You now need to take note how the home catch and Polaroid are stuck onto the touchscreen and imitate it on the shift screen. Uproot all glass and glue from the casing. The best cement is the 3m twofold sided tape that is pre-cut out for the iPad. The trickiest part is to crease the link inside the packaging so it doesn't prevent the touchscreen from sitting flush. Observe the old one to perceive how it overlays.

Advertisement